howtos:integrate_f5_ltm_and_afm_with_crowdsec_ips
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| howtos:integrate_f5_ltm_and_afm_with_crowdsec_ips [26/05/2022 17:03] – [Getting Started] domingo | howtos:integrate_f5_ltm_and_afm_with_crowdsec_ips [26/05/2022 17:07] – [Setup F5] domingo | ||
|---|---|---|---|
| Line 56: | Line 56: | ||
| Next up is creating an icall script in tmsh: | Next up is creating an icall script in tmsh: | ||
| < | < | ||
| - | tmsh | + | # tmsh |
| - | create sys icall script crowdsec | + | (/ |
| </ | </ | ||
| Line 79: | Line 79: | ||
| Next up is to set a timer. | Next up is to set a timer. | ||
| - | Be careful how often you want the script to run if you use the AFM address list. When the script imports into the address list the mcpd daemon gets quite busy and it can take 10-15 minutes for it to finish. If you run it too often you might loose access to the webui because mcpd can't respond in time. | + | **Be careful how often you want the script to run if you use the AFM address list**. When the script imports into the address list the mcpd daemon gets quite busy and it can take 10-15 minutes for it to finish. If you run it too often you might loose access to the webui because mcpd can't respond in time. |
| You will not find the same limitation if you only import to the external data group, as it only takes a second or two to import. | You will not find the same limitation if you only import to the external data group, as it only takes a second or two to import. | ||
howtos/integrate_f5_ltm_and_afm_with_crowdsec_ips.txt · Last modified: 20/07/2022 11:12 by domingo